Related Manuals for USX-MOUNT WMM012-01
Summary of Contents for USX-MOUNT WMM012-01
- Page 1 WMM012-01 INSTRUCTION MANUAL For 26-60" TV If you have any questions along the way, just give us a call 1-800-460-0956 or mail to customerservice@x-mount.com. We’re ready to help!
- Page 2 CAUTION: PLEASE READ ENTIRE MANUAL PRIOR TO USE AND SAVE THESE INSTRUCTIONS Before getting started, let’s check below lists to make sure it is just right for you! MAX:400mm/15.75" (MIN:75mm/2.95") Check your TV VESA is within No? This mount is NOT compatible. Min and Max size MAX:400mm/15.75"...
- Page 3 Dimensions TV INTERFACE MAX:400mm[15.75in] MIN:75mm[2.95in] 400mm [15.75in] MIN: 75mm [2.95in] WALL PLATE TOP VIEW - EXTENDED SIDE VIEW - RETRACTED 203mm [0.35in] [8.00in] +5° 236mm 435mm [9.29in] [17.13in] -15° 406mm [16.00in] FULLY ASSEMBLED MOUNT TOP VIEW - RETRACTED TOP VIEW - EXTENDED MAX:400mm[15.75in] 26mm [1.02in]...
-
Page 4: Parts And Hardware
Parts and Hardware WARNING: This product contains small items that could be a choking hazard if swallowed. Before starting assembly, verify all parts are included and undamaged. If any parts are missing or damaged, do not return the damaged item to your dealer; contact Customer Service. - Page 5 Parts and Hardware for STEP 2 Lag Bolt Wall Plate Allen Key Mounting template Velcro x3 Concrete wall anchor (NOT INCLUDED) Contact us at telephone 1-800-460-0956 (USA) or mail to customerservice@x-mount.com. to have these additional pieces shipped directly to you. Concrete Wall Anchor 4pcs 8"(423.2mm)
-
Page 6: Step 1 Attach Brackets To Tv
STEP 1 Attach Brackets to TV 1-1 Select TV Screws... - Page 7 1-2 Figure out the suitable position of brackets HIGH MOUNTING HOLES LOW MOUNTING HOLES TV BRACKETS MUST BE LEVEL INSTALL UP/DOWN IF NEEDED...
- Page 8 1-4 Attach the TV Plate 1-3 Need Spacer? No, choose suitable screws and washers. Yes, choose suitable screws, washers and spacers. Tips: If you need to combine M6/M8(c/e/f) screws with 2.5mm spacers( i ), you have to remove the inner circle.
- Page 9 STEP 2A Attach Wall Plate to Wall Wood Stud Option CAUTION: Avoid potential personal injury or property damage! ● Drywall covering the wall, must not exceed 5/8 in. (16 mm). ● Minimum wood stud size: common 2 x 4 in. (51 x 102 mm) nominal 1½ x 3½ in. (38 x 89 mm). ●...
- Page 10 3. Drill pilot holes using a 5/32 in. (4 mm) diameter drill bit. IMPORTANT: Pilot holes must be drilled to a depth of 2.36 in. (60 mm). Be sure to drill into the center of the studs. 4. Install wall plate using lag bolts .
- Page 11 STEP 2B Attach Wall Plate to Solid Concrete Wall CAUTION: Avoid potential personal injury or property damage! ● Mount the wall plate assembly unit directly onto the concrete surface. ● Minimum solid concrete thickness: 8 in. (203 mm). 1. Position the mounting template on the wall at your desired height. Level the mounting template and mark the hole locations.
- Page 12 3. Insert anchors. CAUTION: Be sure the anchors are seated flush with the concrete surface. 4. Insert wall plate using lag bolts . Tighten the lag bolts only until they are pulled firmly against the wall plate. CAUTION: Improper use could reduce the holding power of the lag bolt. DO NOT over-tighten the lag bolts.
- Page 13 STEP 3 Wall Plate lnstallation lntegrity Test Before hanging TV, please try to pull the mount to make sure that it has been assembled on the wall tightly. 100 LBS (45.5 kg)
- Page 14 STEP 4 Hang and Secure TV to Wall Plate...
- Page 15 STEP 5 Adjustments 5-1 TV leveling adjustment (±3°): Loosen 2 leveling bolts on the rear of TV plate by maximum 2 turns, adjust to level and retighten to secure. ±3° Loosen Tighten...
- Page 16 5-2 Tilting angle adjustment (+5°/-15°) ： Pull TV to your desired angle and fasten 2 tilting bolts with Allen key +5° +5° -15° -15°...
- Page 17 5-3 Cables manage: Manage TV cables orderly and guide them through the velcros. Velcro...
Need help?
Do you have a question about the WMM012-01 and is the answer not in the manual?
Questions and answers