2 SETUP
4
Info
An assistant prevents the motorcycle from falling
over.
To avoid damaging the motorcycle during the setup,
leave the protective film on the vehicle until you
have finished.
–
Remove and unpack the separate enclosure and attach-
ments. Check that the scope of supply is complete using
the enclosed packing list.
–
Remove the two cable ties on the triple clamp.
–
Have a lift stand available.
Lift stand (78129955100)
–
Together with an assistant, take the vehicle off the pallet.
–
Position the vehicle on a lift stand.
–
Check the vehicle and attachments for transport damage.
–
Install the shock absorber. (
402051-01
–
Position the turn signal indicator lamp
speedometer bracket.
H01768-10
–
Position the connector retainer and speedometer on the
upper triple clamp.
–
Mount and tighten screws
Guideline
Remaining screws,
chassis
–
Route the clutch line with the clutch master cylinder
toward the front between the upper and lower triple
402736-10
clamps.
–
Install the fork legs. (
p. 22)
1
in the
2
.
M6
10 Nm (7.4 lbf ft)
p. 23)