KTM 350 EXC-F 2018 Setup Instructions page 17

–
Mount and tighten screw
Guideline
Remaining screws,
chassis
–
Mount and tighten screw
Guideline
Remaining screws,
chassis
–
Mount and tighten screw
tact disk.
Guideline
Remaining screws,
chassis
E00489-10
–
Connect the tail light plug-in connector to the main wiring
harness plug-in connector.
–
Mount engine electronics control unit on the holder.
Info
The wiring harness runs under the engine electron-
ics control unit.
E00498-10
–
Position the main silencer. Mount screws
washers, but do not tighten yet.
–
Attach spring
Spring hook (50305017000)
–
Tighten screws
Guideline
Remaining screws,
chassis
E00487-10
–
Attach the side cover in area
–
Mount and tighten screw
Guideline
Screw, sub-
frame
–
Mount and tighten screw
Guideline
Remaining screws,
E00494-10
chassis
–
Install the battery. (
–
Install the fuel tank. (
bl
with the collar bushing.
M6 10 Nm (7.4 lbf ft)
bm
.
M6 10 Nm (7.4 lbf ft)
bn with negative cable and con-
M6 10 Nm (7.4 lbf ft)
9
8
.
9
.
M6 10 Nm (7.4 lbf ft)
A
and engage it in area
7
.
M8 35 Nm (25.8 lbf ft)
6 .
M6 10 Nm (7.4 lbf ft)
p. 28)
p. 34)
2 SETUP
with the
B
.
Loctite ® 2701™
15