Table of Contents
Advertisement
Connecting FM/AM antennas
Fix the claw
into the slot
Ground (GND terminal)
For minimum interference, connect
the antenna GND terminal to a good
earth ground. A good earth ground is
a metal stake driven into moist earth.
1
Connect the supplied AM loop antenna to the AM
ANT terminal. Place the AM loop antenna on a
shelf or attach it to a stand or wall.
2
Connect the supplied FM wire antenna to the FM
ANT terminal. Extend the FM wire antenna and fix
its ends to the wall.
For better FM stereo reception, connect an
external FM antenna (not supplied).
Notes:
– Adjust the position of the antennas for optimal
reception.
– Position the antennas as far as possible from your TV,
VCR or other sources of radiation to prevent
unwanted interference.
AM Loop
Antenna
1
FM Wire
Antenna
2
VIDEO OUT (DVD
FM
ANT
COMPONE
GND
AM
ANT
75W UNBAL
TV IN
AUX IN
V
FM
ANT
GND
AM
ANT
Connecting the power cord
DVD Receiver
VIDEO OUT (DVD ONLY)
DIGITAL IN
S VIDEO
FM
ANT
COAXIAL
COMPONENT
GND
PCM/DTS
VIDEO
q DIGITAL
AM
ANT
SYSTEM
CONNECTOR
75Ω UNBAL
TV IN
AUX IN
LINE OUT
TO NS-SW300
System Control Cable
Subwoofer
After everything is connected properly, plug
the AC power cord into the power outlet.
Never make or change any connections with the
power switched on.
Note:
– Refer to the type plate on the rear of the DVD
receiver and subwoofer for identification and supply
ratings.
Connections
TV
To an
AC
wall
outlet
15
Advertisement
Table of Contents
