Mosa GE 15 PS SX Use And Maintenance Manual page 22

ASSEMBLY
The CTL accessory cannot be removed from the machine and used separately (actioned manually or following vehicles) for
the transport of loads or anyway for used different from the machine movements.
TRAILERS
The machines provided for assembling the accessory (slow towing trolley) can be towed up to a maximum speed
of 40 Kms/hour on asphalted surfaces.
Towing on public roads or turnpikes of any type IS EXCLUDED, because not in possesion of the requirements by
national and foreign traffic norms.
Nota: Lift the machine and assemble the parts as shown in the drawing
For assembling the generating set on the trolley CTL15
please keep to following instructions:
1) - Lift the generating set (by means of suitable hook).
2) - Slightly fix the jaw (3) of the parking foot to the
barwith the M10x20 screws, the M10 nuts and the
washers (so as to let the foot sprag go through).
3) - Split (unscrewing them) the two parts of the foot
(4S-4I) to be able later to assemble them on the
jaw.
4) - Introduce into the jaw (3) the upper part (4S) of
the foot and screw again the lower part (4I), then
tighten the screws (4V) of the jaw to the towbar
and block momentaneously with the lever (4L) the
whole foot.
5) - Assemble on the machine the towbar (5) complete
of foot with the M10x20 and M10X25 screws, nuts
and washers.
6) - Assemble the axle (7) to the base of the machine
with the M10x25 screws and relative washers (two
per part) so that their supports coincide.
8) - Insert the wheel (9) on the axle then screw the self
blocking nuts (8).
9) - Pump the tyre (9) bringing the pressure to four
atms.
10) - Lower the machine to the ground and place the
parking foot definitively (regulating at the best
height).
ATTENTION
!
Do not substitute the original tires with other types.
ATTENTION
!
7
9
8
M
CTL15 6.19
REV.0-09/12