Connect+Rig An Hdmf M Or A Dvl Device To The Hdmi Input - Toshiba FSTPURE 26HF84 Owner's Manual

÷
÷
Connecting an HDM TMor a OVH device to the HDM input
The HDMI[q input on your TV receives digital audio and [1] HDMt = High-Definition Multimedia interface.
uncompressed digital video from an HDMI device or [2] DVt = Digital Video Interface.
uncompressed video from a DVl [2]device.
This input is designed to accept HDCP [3;program material
in digital form from EIA/CEA-861/861 B- compliant [4]
consumer electronic devices (such as a settop box or DVD
player with HDMI or DVl output.
The HDMI input is designed for best performance with
1080i high-definition video signals, but will atso accept and
display 480i, 480p, and 720p signals.
[3] HDCP = High-bandwidth Digital Content Protection.
[4] E/A/CEA -861/861B compliance covers the
transmission of uncompressed digital video with high-
bandwidth d_gita/ content protection, which is being
standardized for reception of high-definition video
signals.
Because this is an evolving technology; it is possible
that some devices may not operate property with the
T_
Nots: This TV is not intended for connection to and
should not be used with a personal computer.
To connect an HDMJ device, you win need:
. one HDMI cable (type A connector)
For proper operation, it is recommended that you use
a short HDMt cable. You shous'd not encounter
difficulty if you use an HDM/ cable which is shorter
than 16.4ft (5m).
HDM/ cable transfers both video and audio. Separate
analog audio cables are not required (see illustration
below).
You must set the HDMI setting to HDMI in the
AUDIO menu (see page 41).
Some CDVs (Video CDs) may not output digital audio
signals./n that case, you may hear sound by connecting
analog audio cables. If you connect analog audio cables
with this connection (see "To connect a DV/ device, you
wilt need" in right column).
HDMmdevice
TV
To ensure that the HDM/ or DW device is reset
propertK it is recommended that you foflow these
procedures:
° VV_1en turning on your electronic components, turn
on the TV firsL and then the HDM/ or DV/ device.
* When turning offyour electronic components, turn
off the HDMI or DW device first, and t,_en the T_L
To connect a DVt device, you will need:
• one HDMI-to-DVI adapter cabie
(HDMI type A connector)
For proper operation, tile length of an HDM/-to-D Vt
adapter cable should not exceed 9.8 ft (3m). The
recommended length is 6.6 ft (2m).
• one pair of standard analog audio cables
An HDM!-to-DV/ adapter cable transfers only video.
Separate analog audio cables are required (see
illustration below).
You must set the HDM] setting to DW in the AUDIO
menu (see page 41).
DVI device
TV
HDMI
÷
HDMI, the HDMI logo, and High-Definition Multimedia
Interface are trademarks or registered trademarks of HDMI
Licensing, LLC.
14
3R40121A/E P07-15
÷
6/7/04, 18:57