Important Notes On Operation; Cleaning And Care - Klarstein MIDNIGHT SUN Manual

IMPORTANT NOTES ON OPERATION

• All settings must be reset after battery replacement.
• If the buttons on the remote control no longer respond, replace the old
batteries completely with new batteries.
The remote control is powered by two 1.5 V AA batteries. Replace the batteries
as soon as the battery symbol flashes, otherwise the remote control will no
longer be able to control the heater.
• If the heating cannot be switched on by remote control, check whether the set
temperature is higher than the room temperature. Only then will the heater
turn on.
• To use the programming mode, make sure that it is set to ON by pressing the
MODE key for a long time. If you prefer to operate the heater manually, set
the programming mode to OFF.
• Do not cover or touch the temperature sensor of the remote control.
• Leave the remote control open in the room. Do not place the remote control
in the sun and do not put it in a drawer / pocket or under pillows / blankets.
Otherwise, the temperature sensor will not work properly.
• Unplug the heater from the wall outlet if you are not going to use it for a long
time.

CLEANING AND CARE

Note: Turn off the unit and unplug it from the power outlet. Wait until the unit
has completely cooled down before cleaning it.
• Use a vacuum cleaner to clean the ventilation slots and grilles.
• Remove dust on the outside surfaces with a damp (not wet) cloth.
• Do not use strong cleaning agents or abrasives.
• Do not spray the device with liquids or immerse it in water or other liquids.
• Never open the heater housing.
EN
47