Operation In Detail - Klarstein MIDNIGHT SUN Manual

EN
42

OPERATION IN DETAIL

To pair the receiver with the remote control
Turn on the unit using the built-in receiver or the plug-in receiver and press the
indicator light for 3 seconds to make it blink. Then press the °C / °F and MODE
buttons simultaneously to pair the remote and receiver until a long beep is heard.
• Pairing should be completed within 1 minute, otherwise you will need to turn
the unit back on.
• Turn the unit off and on again if you want to pair it with another remote
control.
• Before pairing, turn off the devices you do not want to pair.
Set the time and day
It is important that the time and day are set accurately if you want your
programmed heating periods to start on time.
1 Press and hold the TIME button for 3 seconds until the year of the date
flashes.
2
Use the or button to set the year. Then press the TIME button to save
the entry and continue setting month/day/hours/minutes in a similar
manner.
3 Finally, press the TIME button again to save all entries and exit the setting.
Switching the thermostat on and off manually
• Press the ON/OFF button to manually turn the heater on or off. When the
heater is off, the remote control display shows the current room temperature
reading. When the heater is on, press
temperature.
• If the set temperature is below the room temperature, the heater will turn off.
• When the set temperature is above the room temperature, the heater turns
on and the heating icon
or to increase or decrease the set
appears on the remote control display.