Numeric Error Codes - Lenovo 20QA001QIX Hardware Maintenance Manual

Table 2. Numeric error codes (continued)
Symptom or error
0189
Invalid RFID configuration information area—The
EEPROM checksum is not correct.
0190
Critical low-battery error
0191
System Security—Invalid Remote Change requested.
0199
System Security— Security password retry count
exceeded.
0270
Real Time Clock Error.
0271
Check Date and Time settings.
1802
Unauthorized network card is plugged in—Turn off and
remove the network card.
1820
More than one external fingerprint reader is attached.
Power off and remove all but the reader that you set up
within your main operating system.
2100
Detection error on HDD0 (Main HDD)
2101
Detection error on SSD1 (M.2)
2102
Detection error on SSD2 (M.2)
2110
Read error on HDD0 (Main HDD)
2111
Read error on SSD1 (M.2)
2112
Read error on SSD2 (M.2)
2200
Machine Type and Serial Number are invalid.
2201
Machine UUID is invalid.
FRU or action, in sequence
System board
1. Charge the battery.
2. Battery
1. Run the ThinkPad Setup program, and then save
current setting by pressing F10.
2. System board
1. Run the ThinkPad Setup program, and then save
the current setting by pressing F10.
2. System board
System Real Time Clock is not functional. Have the
computer serviced.
Neither the date nor the time is set in the
computer. Set the date and time, using the
ThinkPad Setup program.
1. Remove wireless network card.
2. System board
Remove all but the reader that you set up for the
authentication.
1. Reseat the hard disk drive.
2. Hard disk drive
3. System board
1. Reseat the M.2 solid-state drive.
2. M.2 solid-state drive
3. System board
1. Reseat the M.2 solid-state drive.
2. M.2 solid-state drive
3. System board
1. Reseat the hard disk drive.
2. Hard disk drive
3. System board
1. Reseat the M.2 solid-state drive.
2. Main M.2 solid-state drive
3. System board
1. Reseat the M.2 solid-state drive.
2. Main M.2 solid-state drive
3. System board
System board
System board
Chapter 4
.
Related service information
37