Yaesu VR-5000 Operating Manual page 33

VOICE Scanning
1. Press the [ F ] key momentarily, then press the [ V/M ( MW )] key.
2. Rotate the DIAL knob to set the cursor to the "Channel" menu option, then press the
[ ENT ( SET )] key.
3. Using the [ ( ) / ( )] keys or the keypad, select the memory bank on which you
wish to perform VOICE scanning, then press the [ BANK ] key.
4. Rotate the DIAL knob to set the cursor to the
"VCS" menu option, then press the [ • ( BEEP )]
key to enable VOICE scanning.
5. Rotate the DIAL knob to set the cursor to the
"E N D " m e n u o p t i o n , t h e n p r e s s t h e
[ ENT ( SET )] key.
6. Confirm that the cursor is on the "WRITE"
menu option, then press the [ ENT ( SET )] key to save the new setting and exit to normal
operation.
Setting the Scan-Resume Technique
Three options for the Scan-Resume technique are available. These options may be set
independently for Memory Scan, VFO Scan, and PMS (Band-Segment) Scan operation.
DELAY: In this mode, the scanner will halt on a signal it encounters, and will hold until the
signal disappears. After the squelch closes when the received station quits trans-
mitting, scanning resumes automatically. The scanning-restart delay time (default
interval: 2 seconds) is set by the "M-P.DELAY" menu selection.
PAUSE: In this mode, the scanner will halt on a signal it encounters. After a programmed
time interval (set by the "M-PAUSE" menu selection), the scanner will resume,
whether or not the signal has disappeared.
HOLD: In this mode, the scanner will halt on a signal it encounters. It will not restart
automatically; you must manually re-initiate scanning if you wish to resume.
However, the "M-HOLD" menu selection provides a "restart" window within which,
if the incoming signal disappears, the scanner will resume; this allows scanning to
proceed if the squelch is opened by a brief incoming signal burst.
Here is the procedure for setting up the Scan-Resume mode for Memory scanning:
1. Press the [ V/M ( MW )] key, if necessary, to enter the "MR" (Memory Recall) mode.
2. Use the [ ( ) / ( )] keys to select the desired memory bank.
3. Press the [ BANK ] key, then rotate the dial to select the "ScanStop" menu option.
4. Press the [ • ( BEEP )] key, repeatedly if necessary, to select "DELAY," "PAUSE," or
"HOLD," as desired.
5. Rotate the DIAL knob to select "END," then press the [ ENT ( SET )] key .
6. The display should now indicate "WRITE;" press the [ ENT ( SET )] key again to save
the new setting and exit to normal operation .
VR-5000 O M
Scanning
31