Memory Operation; Main Memory System; Memory Storage; Memory Recall - Yaesu VR-5000 Operating Manual

Memory Operation

The VR-5000 provides a wide variety of memory system resources. These include:
Ì 2000 main memory channels, which may be separated into as many as 100 memory groups.
Ì 50 sets of band-edge memories (also known as "Programmable Memory Scan" channels).
Ì Five PS (Pre Set) memory channels, providing one-touch storage and recall of prime
receiving frequencies.

Memory Storage

1. Select the desired frequency, while receiving on the MAIN VFO. Be sure to set up any
special features (described later), if you wish to store them.
2. Press the [ F ] key momentarily, then press the [ V/M ( MW )] key to enable the memory
storage process.
3. To designate the channel for storage into a particular memory group, proceed to the
next step; otherwise press the [ COPY ( REC )] key twice to save the entry and exit to the
VFO mode. If you are not designating the channel into a memory group, storage of this
frequency is now complete.
4. If designating the channel for storage into a memory group, confirm that the cursor is
on the "Channel" menu, then press the [ ENT ] key.
5. Press the [ ( ) / ( )] keys to select the desired memory group to be stored, then
press the [ ENT ] key. Pressing the [ ( )] key once will select an all-new memory
group, if this is what you want to do.
6. Rotate the DIAL knob one click to the right to set the cursor to the "Channel" menu,
then press the [ COPY ] key.
7. Confirm that the cursor has switched to the "WRITE" menu selection, then press the
[ ENT ] key to save the entry and exit to the VFO mode.

Memory Recall

1. While operating in the VFO mode, press the [ V/M ( MW )] key to switch to the "memory"
mode.
2. Press the [ ( ) / ( )] keys to select the desired memory group, or press the desired
memory group number from the keypad (include any leading zeroes: press [ 0 ] « [ 2 ]
for memory group 2).
3. Now rotate the DIAL knob to select the desired memory channel within the selected
memory group.
4. To return to the VFO
mode, press the [ V/
M ( MW )] key again.
20
M M S
VR-5000 O
Memory Bank "00"
Memory Channel "01"
M