Troubleshooting Guide - Bauknecht GSX 5597/1 Instructions For Use Manual

TROUBLESHOOTING GUIDE

FAULT
E1
E2 - E9
E3
E4
E5
E6
E7
E8
• Alarms E1, E2, E3, E4, E8, E9 automatically "halt" the wash programme in progress, moving it to end of cycle.
• Alarms E5, E6 interrupt the wash programme in progress and, once the fault has been remedied, allow the
programme to continue.
• Alarm E7 is displayed at the end of the wash programme, which is nonetheless allowed to finish since the
appliance is not prevented from working properly.
To "reset" an alarm, you must:
• open or close the door or switch the dishwasher off and then back on again. After this course of action the
dishwasher may be programmed again.
Should the fault persist, contact an authorized Service Centre.
DESCRIPTION
The anti-flood system has been tripped (where present).
The system that controls the water level in the dishwasher has been tripped.
The dishwasher is unable to heat the water.
Temperature probe disconnected.
The dishwasher is unable to load water.
The dishwasher is unable to drain water from the tank.
The dishwasher is unable to measure the amount of water loaded precisely.
Rack water distribution fault.
21