Dust Extraction; Dust Box; Reducer; Operation - Parkside Performance PMS 160 B2 Translation Of The Original Instructions

Dust extraction

WARNING! RISK OF FIRE!
► There is a risk of fire when working with
power tools that are fitted with a dust collec-
tion box or can be connected to a vacuum
cleaner via the vacuum cleaner adapter! In
unfavourable conditions, e.g. when sparks
are flying while sanding metal or metal
residues in wood, wood dust in the dust sack
(or in the vacuum cleaner dust bag) can
spontaneously ignite. This is a particular risk
if the wood dust is mixed with paint residues
or other chemicals and the workpiece has
become hot after being worked for a long
time. Therefore, do not allow the workpiece
to overheat and always empty the dust box
or the dust bag in the vacuum cleaner before
taking a break from work.
Wear a dust mask!
NOTE
► Perforated sanding sheets are required for
dust extraction.

Dust box

Connecting
Slide the dust box 3 onto the appliance.
♦
Turn the dust box 3 towards the
to lock it.
Removal
Turn the dust box 3 towards the
♦
Then pull the dust box 3 off the appliance
(see detailed illustration on fold-out page).
NOTE
► To ensure optimum dust extraction, empty the
dust box 3 regularly.
To do this, remove the dust box 3 from the
♦
appliance as described above. Open the dust
box 3 by pressing the release button 2 and
pulling off the rear part. Now remove the dust
bag 4 (see detailed illustration on fold-out
page). Clean the dust bag 4 thoroughly by
tapping it out.
│ GB │ IE
■ 6

Reducer

Connecting
Push the reducer 5 into the adapter connec-
♦
tion 6.
♦ Push the hose of a suitable vacuum cleaning
appliance (e.g. a workshop vacuum cleaner)
onto the reducer 5.
Removal
♦ Pull the hose of the vacuum cleaner off the
reducer 5.
Pull off the reducer 5.
♦

Operation

CAUTION!
► Ensure that the appliance is switched off
before connecting it to the mains.
NOTE
► Always switch the multi-sander on before
applying it to the material, then move it over
the workpiece.
Switching on and off
Switching on the appliance
Move the ON/OFF switch 1 to the "I"
♦
symbol
position.
Switching off the appliance
Move the ON/OFF switch 1 to the "0"
♦
symbol.
position.

Working procedures

■ Switch the appliance on before applying it to
the workpiece.
■ Apply minimal pressure when working.
■ Work at a constant speed.
■ Change the sanding sheets regularly.
■ Never use the same sanding sheet for sanding
different materials (e.g. wood followed by
metal). Optimum sanding results can only be
achieved by using clean sanding sheets.
■ Clean the sanding sheet every once in a while
using a vacuum cleaner.
PMS 160 B2