Maintenance And Cleaning; Disposal - Parkside Performance PMS 160 B2 Translation Of The Original Instructions

■ Sand hard-to-reach places with the front or side
edge of the sanding sheet on the sanding plate.
■ Guide the sander over the workpiece in parallel
and use overlapping sanding motions.
■ After completing the task, lift the appliance from
the workpiece and then switch it off.

Maintenance and cleaning

WARNING!
► Always remove the plug from the mains power
socket before carrying out any work on the tool.
The appliance is maintenance-free.
■ Always clean the appliance directly after
completion of work.
■ Use a dry cloth to clean the housing.
■ Remove any sanding dust stuck to the appliance
with a brush.
■ Never use sharp objects, petrol, solvents or
cleaning agents which can damage plastic.
Do not allow any liquids to get into the interior
of the appliance.
■ Always keep the ventilation openings free of
obstructions.

Disposal

Applies only to France
The product, its packaging and the operating
instructions are recyclable. They are subject to an
extended manufacturer responsibility and will be
collected separately.
PMS 160 B2
Do not dispose of power tools
in your normal domestic waste!
The adjacent symbol of a crossed-out
dustbin means that this appliance is
subject to Directive 2012/19/EU. This directive
states that this appliance may not be disposed of in
the normal household waste at the end of its useful
life, but must be taken to specially set-up collection
locations, recycling depots or disposal companies.
The disposal is free of charge for the user.
Protect the environment and dispose of this
appliance properly.
Your local community or municipal
authorities can provide information on
how to dispose of the worn-out product.
The packaging is made from environ-
mentally friendly material and can be
disposed of at your local recycling plant.
Dispose of the packaging in an
environmentally friendly manner.
Note the labelling on the packaging
and separate the packaging material
components for disposal if necessary. The pack-
aging material is labelled with abbreviations (a)
and numbers (b) with the following meanings:
1–7: plastics, 20–22: paper and cardboard,
80–98: composites.
GB │ IE │
7 ■