Turning Power On/Off - Fujitsu CT114 Instruction Manual

Set Up the Cleaver

Turning Power ON/OFF

Turning the cleaver ON
1. Remove any fiber before powering on the cleaver.
It is possible for the left clamp to impact and break fibers, since the left clamp stage
moves forward to "Reset" when the power is turned on.
2. Press the ON/OFF key and hold until the green LED turns on.
3. Press the SET key to set the cleaver in its "Ready" state.
The left clamp stage will reset, and the cleaver will be ready to use.
Power ON
Press SET
CT114_Rev2
Ready to cleave
30