Labeling Memories - Yaesu FT-60R Operating Manual

M M
EMORY
You may wish to append an alpha-numeric "Tag" (label) to a memory or memories, to aid
in recollection of the channel's use (such as a club name, etc.). This is easily accomplished
using the Set Mode.
1. Recall the memory channel on which you wish to append a la-
bel.
2. Press the [ F/W ] key, then press the [ 0 (
Set mode.
3. Rotate the DIAL knob to select Set Mode Item 28: NM WRT.
4. Press the [ F/W ] key momentarily to display the previously stored
label (if any).
5. Press the [ F/W ] key again to clear any previous label.
6. Rotate the DIAL knob to select the first digit of the desired la-
bel.
7. Press the [ F/W ] key to move to the next character.
8. If you make a mistake, press the [ ( MHz )] key to back-space the cursor, then re-enter
the correct letter, number, or symbol.
9. Repeat steps 5 through 7 to program the remaining letters, numbers, or symbols of the
desired label. A total of six characters may be used in the creation of a label.
10. When you have programmed a label which is under 6 characters, press and hold in the
[ F/W ] key for one second to confirm the label (if the label is
exactly 6 characters in length, you do not need to press and hold
in [ F/W ] ).
11. When you have completed the creation of the label, press the PTT key to save the
label and exit.
To display the alpha-numeric "Tag" (label):
1. Set the FT-60R to the "MR" (Memory Recall) mode, and recall
the memory channel on which you wish to display its label.
2. Press the [ F/W ] key, then press the [ 0 (
Set mode.
3. Rotate the DIAL knob to select the Set Mode Item labeled 27:
NAME.
4. Press the [ F/W ] key momentarily to enable adjustment of this
Item's setting.
5. Rotate the DIAL knob to set this Set Mode Item to "ALPHA"
(thus enabling the alpha-numeric display).
6. Press the PTT key to save the new setting and activate the al-
pha-numeric Tag.
30
ODE
L M
) SET ] key to enter the
) SET ] key to enter the
FT-60R O M