Garmin G1000 Diamond DA62 Pilot's Manual page 77

When set to Auto (default), the GPS CDI scale automatically adjusts to the desired limits based upon the
current phase of flight (Figure 2-26, Table 2-1).
Departure
• Once a departure procedure is activated, the CDI is scaled for departure (0.3 nm).
• The system switches from departure to terminal CDI scaling (1.0 nm) under the following conditions:
- The next leg in the departure procedure is not aligned with the departure runway
- The next leg in the departure procedure is not a CA, CD, CF, CI, CR, DF, FA, FC, FD, FM, IF, or TF (see
Glossary for leg type definitions)
- After any leg in the departure procedure that is not a CA or FA
• At 30 nm from the departure airport, the enroute phase of flight is automatically entered and CDI scaling
changes to 2.0 nm over a distance of 1.0 nm, except under the following conditions:
190-01895-00 Rev. A
Figure 2-25 GPS CDI Settings
(AUX-System Setup Page)
Enroute
Terminal
(Oceanic if >200 nm
from nearest airport)
Figure 2-26 Automatic CDI Scaling
Garmin G1000 Pilot's Guide for the Diamond DA62
FLIGHT INSTRUMENTS
Refer to accompanying
approach CDI scaling figures
Terminal Approach
Missed
Approach
63