Adding An External Device - Xerox CSX 2000 Installation Manual

214

Adding an External Device

1.
If the added external device is a disk it will be used for saving files and not for
the application itself.
2.
If you are adding an MO device, connect the adapter, and browse to:
E:\Files_nt\Drivers\mo_drv and select setup.exe.
3.
If the device is any other than an external disk, it is preferable to remove the
Creo application prior to the installation and then reinstall it after the
installation is complete.
To add an external SCSI device to the CSX2000 Color Server:
1. Verify that the CSX2000 Color Server is shut down.
2. If the CSX2000 Color Server is from serial numbers 002474-
002475 or from serial number 002478 onwards, loosen the 2
screws and unplug the Termination of the CSX2000 Color Server
located on the bottom rear end of the DFE. See the following
figure and then proceed to step 4.
I1 I3
I0
I2
Rear of CSX2000 Color Server Showing Termination on I3
Chapter 6 Adding an External SCSI Device
S0 S1
S0
S3 S3
S2
S2
S1 S1
S0 S0
S1
IN IN
OUT1 OUT1
OUT2 OUT2
960 960
CH0 CH0
CH1 CH1
CH2 CH2
CH3 CH3
3VPW 3VPW
5VPW 5VPW
5VFL 5VFL
MON MON
External SCSI
Termination on I3