Table of Contents
Advertisement
FlameSpec IR3 HD User Manual
Model Number Descrip on
Model No are defined as follows
FLS-IR3-HD - A S X X
1.2.1
Enhanced performance op ons
Op on 3: Increased false alarm immunity in presence of hot CO2. Recommended for Hangar,
Helideck and Petroleum Loading Racks
Op on 5: Design for, but not limited to, automo ve spray paint applica ons where compliance
with 0.5s response (per NFPA 33) is needed
Internal tests
During normal opera on, the flame detector performs self-tests of its op cs, electronics and so ware.
These include a periodic BIT (Built-In-Test) in which the sensors and window cleanliness are tested. Any
detected fault is indicated as shown in Table 4 (in sec on 4.1). During "Dirty Window" fault the detec on
sensi vity is significantly reduced, while "Fault" refers to cri cal faults which prevent flame detec on.
For more information & technical support: (+1) 714-671-8500 · support@fg-detection.com
F101V0020.08
:
0
Standard with RGB camera, no Hart and not SIL cer fied.
1
Standard with RGB camera
2
Like model 1 with Near IR camera
3
Like model 1, but recommended for Hangar, Helideck, Petroleum
Loading Racks with RGB camera
4
Like model 3 with Near IR camera
5
Like model 1 but with a fast response mode that is designed for,
but not limited to, automo ve spray paint applica ons where
compliance with 0.5s response (per NFPA 33) is needed. With RGB
camera
1
M25
2
¾" NPT
2
Advertisement
Table of Contents
