Model Number Description; Internal Tests - FGD FlameSpec IR3-H2 User Manual

FlameSpec IR3-H2 User Manual

Model Number Description

Model No are defined as follows
FLS-IR3-H2 - A S X X
1.2.1 Enhanced performance options
Option 5: Design for, but not limited to, enclosed space protection like automotive spray paint applications
where compliance with 0.5 s response (per NFPA 33) is needed

Internal tests

During normal operation, the flame detector performs self-tests of its optics, electronics and software. These
include a periodic BIT (Built-In-Test) in which the sensors and window cleanliness are tested. Any detected
fault is indicated as shown in Table 4 (in section 4). During "Dirty Window" fault the detection sensitivity is
significantly reduced, while "Fault" refers to critical faults which totally prevent flame detection.
For more information & technical support: (+1) 714-671-8500 · support@fg-detection.com
F150V0020.09
:
0 Standard, no Hart and not SIL certified.
1 Standard
5 Design for, but not limited to, automotive spray paint applications
where compliance with 0.5 s response (per NFPA 33) is needed.
Generally used for enclosed spare protection.
1 M25
2 ¾" NPT
2