3.7 RS-232 and RS-485
To connect via RS-232 or RS-485, connect to the RS232 / RS485 jack on the base board.
UART1
UART0
RS232/
Full/Half Duplex
RS485
Fig. 3.5: RS-232 connector
The switch labeled RS-232 / RS-485 selects between RS-232 and RS-485 mode on the jack.
In RS-485 mode, the switch labeled Full Duplex / Half Duplex selects full- or half-duplex mode, respec-
tively. It has no effect in RS-232 mode, which is always full-duplex.
3.8 TTL UART
UART0 and UART1 are also available through the pin headers P12 UART0 and P30 UART1 next to the RS232 /
RS485 jack. The signal level is 3.3V.
3.9 Ethernet
The RK3399-Q7 has built-in Gigabit Ethernet routed to a standard jack on the evaluation board.
Fig. 3.6: Ethernet jack
The SD card that is shipped with the EVK is configures to automatically retrieve an IP via DHCP and provides
SSH login on port 22.
RK3399-Q7 User Manual
v1.6
© Cherry Embedded Solutions GmbH
Page 9