Xerox Phaser 8560 Advanced Features Manual page 60

Using the Control Panel
To select a Tray 1 mode setting on the control panel:
1.
Select
Paper Tray Setup
2.
Select , and then press the OK button.
Tray 1 Mode
3.
Select the appropriate setting, and then press the OK button.
Using CentreWare IS
To select a Tray 1 mode setting using CentreWare IS:
1. Launch your web browser.
2. Enter the printer's IP address in the browser's Address field.
3. Click Properties.
4. Select the General folder on the left navigation panel, and then select Printer Defaults.
5. Select the appropriate setting in the Tray 1 Mode drop-down list.
6. Click the Save Changes button at the bottom of the page.
Selecting Tray 2–N Mode
The Tray 2–N Mode setting specifies how Tray 2–N paper type is determined when you load
paper in the tray but do not select the paper type on the control panel.
Setting
Dynamic
(Factory default setting)
Static
To select the Tray 2–N mode setting, use one of the following options:
■ The printer's control panel
■ CentreWare IS
, and then press the OK button.
Description
Uses the settings from the next print job that prints from the inserted tray
to determine the paper type.
The paper type already set for the inserted trays stays in effect.
Phaser® 8560/8860 Printer
4-10
Printer Settings