Printer installation
Printer installation
Perform this procedure after the Printer is unpacked, and placed in a suitable
location.
If you have not performed the
this section, do it now.
If the Printer is still in the original packing, go to the
Printer
1.
Locate the Output Tray in the cardboard tray removed from the top of
the printer. Install the tray by performing steps a through c.
a.
Do not place the metal spring into the hole. Ensure that the metal spring
extends down against the outside of the cover.
b.
Xerox Phaser 790 Getting Started
procedure.
Standing on the left-hand side of the Printer, hold the Output Tray
as shown.
Place the right-hand arm of the tray into the corresponding hole as
shown.
1. Setting up the Phaser 790
Preparing for the installation
0
301031B-WOL
0
301032B-WOL
procedure in
Unpacking the
1-25