LG MULTI F LMU183HV Installation Manual page 6

SAFETY INSTRUCTIONS
Wiring
DANGER
High voltage electricity is required to operate this system.
Adhere to the NEC code and these instructions when wiring.
Improper connections and inadequate grounding can cause accidental
Always ground the unit following local, state, and NEC codes.
the equipment.
Properly size all circuit breakers or fuses.
The information contained in this manual is intended for use
familiar with the U.S. National Electric Code (NEC) who is
equipped with the proper tools and test instruments.
Failure to carefully read and follow all instructions in this manual can
All electric work must be performed by a licensed electrician
and conform to local building codes or, in the absence of
local codes, with the National Electrical Code, and the
instructions given in this manual.
If the power source capacity is inadequate or the electric work is not
death.
Refer to local, state, and federal codes, and use power wires
NOTE
Do not supply power to the unit until all electrical wiring,
controls wiring, piping, installation, and refrigerant system
evacuation are completed.
System will malfunction.
6
Due to our policy of continuous product innovation, some specifications may change without notification.
©LG Electronics U.S.A., Inc., Englewood Cliffs, NJ. All rights reserved. "LG" is a registered trademark of LG Corp.
Do not share the electrical circuit with other appliances.
heat generation.
Do not use damaged or loose power wiring.
randomly modify or extend the outdoor unit's power wiring.
Ensure that the power wiring will not be pulled nor weight be
placed on the power wiring during operation.
strain relief.
Improperly securing wires will create undue stress on equipment power
Ensure the system is connected to a dedicated power source
that provides adequate power.
If the power source capacity is inadequate or the electric work is not
death.
Properly tighten all power connections.
Do not change the settings of the protection devices.
If the protection devices have been bypassed or are forced to operate
The information contained in this manual is intended for use
familiar with the U.S. National Electric Code (NEC) who is
equipped with the proper tools and test instruments.
Failure to carefully read and follow all instructions in this manual can
result in equipment malfunction and / or property damage.
F
MULTI
F
MULTI MAX
Do not
-