System Start Up - Energizer PS2900H User Manual

Step 2: Crimp the cable with a Rj45 plug which is inside of the cable connector.
B: Connect the grounding cable to ensure that all batteries are grounded. Wiring shall be connected in the
sequence as shown in below.

7.7 System Start up

· When the grid connected system is started, the inverter should be turned on first to avoid the current
pulse of the inverter increasing to the battery pack.
· All installation and operation must comply with local electrical standards.
· Check all power cables and communication cables carefully.
1. Turn on
· First turn on DC switch and then press the POWER switch, firstly Master LED will light up once, and
then the BMS Status LED will light up for 0.5s,Operating Status LED will light up for 1s at the same
time,it means that the system works normally.
13