Operation - Husqvarna PG 400 Petrol Operator's Manual

• Fuel on your skin can cause injury. If you get fuel on
your skin, use soap and water to remove the fuel.
• If you spill fuel on your clothing, change clothing
immediately.
• Do not fill the fuel tank fully. Heat causes the fuel to
expand. Keep a space at the top of the fuel tank.
• Tighten the fuel tank cap fully. If the fuel tank cap is
not tightened, there is a risk of fire.
• Use the fuel tank cap with venting for operation and
storage.
• Before you start the product, move the product to a
minimum of 3 m/10 ft from where you refueled.
• Do not start the product if there is fuel or engine
oil on the product. Remove the unwanted fuel and
engine oil and let the product dry before you start the
engine.
• Examine the engine for leaks regularly. If there are
leaks in the fuel system, do not start the engine until
the leaks are repaired.
• Do not use your fingers to examine the engine for
leaks.
• Keep fuel in approved containers only.
• When the product and fuel is in storage, make sure
that fuel and fuel fumes cannot cause damage.
Introduction
WARNING:
product, you must read and understand the
safety chapter.
WARNING:
adjust the handlebar between the operation
position, the servicing position and the
transport position. The handle is heavy and
must be held tightly. Look around you before
you adjust the handle position, to prevent
damage or injury.
883 - 004 - 20.12.2023

Operation

Before you operate the
Be careful when you
• Drain the fuel in an approved container outdoors and
away from sparks and flames.
Safety instructions for maintenance
• Always put the throttle control to stop position (A),
before maintenance of the product, Refer to
control on page 11 .
• Keep all parts in good condition and make sure that
all fixtures are correctly tightened.
• Do not use a product that is defective. Do the safety
checks, maintenance and the servicing as given in
this manual. All other maintenance work must be
done by an approved service agent.
• Stop the product when you replace the diamond
tools.
• Do the inspection and/or maintenance with the
engine stopped.
• Always let the engine become cool before you do
maintenance of the product.
• Make sure to do the do maintenance of the product
on stable horizontal ground.
• Do the maintenance to make sure that the product
operates correctly. Refer to
13
Product positions
Engine start position
Throttle
Maintenance on page
7