Turning Effectors On Of Off; Settings For Each Effects Processor - Boss SX-700 Owner's Manual

Turning Effectors on or off
This parameter turns the Effectors in use to "Effect On," and
the ones not in use to "Effect Off." The corresponding EFFECT
PARAMETER buttons for Effectors set to "Effect On" light to
show that they are active.
* An Effector set to "Effect Off" normally sends input sound
unchanged to output. (That is, throughput occurs.) If Effectors
connected in parallel are all set to "Effect Off," their sound is
muted,
(Procedure)
1,2 (2)
EFFECT PARAME Ubebheexmnmenmuonconceds
' nod
NUMBERVALUE
ENTERPUSH) uraity
4PARAMETER D>
1 Press the EFFECT PARAMETER button that corresponds to
the effect you wish to turn on or off.
The settings for the selected Effector appear in the display.
) EFFECT PARAMETER
F
a MOD DELAY AFVEAB RSS
—_— ono a on
Effect On/Off
2 Once again, press the EFFECT PARAMETER button that
corresponds to the effect you wish to switch. The effect will
be turned on or off.
You can also toggle the effect on or off by rotating the
VALUE knob.
3 Repeat steps 1 and 2 to turn each effect on/off.
4 When you finish making settings...
- {fyou want to continue with changing another item, make
the modification according to what you want to do.
— Ifyou wish to save the settings, use the Write operation
(p.22).
< MEMO >
While settings parameters (see the next section), pressing the
EFFECT PARAMETER button that corresponds to the Effector
that you're making settings for causes the effect to be switched
on or off while maintaining the parameter settings.
Settings for Each Effects Processor
Each Effector is made up of a number of Parameters. By
individually modifying the values for these parameters, you
can create original effect sounds.
(Procedure)
1 Press the EFFECT PARAMETER button that corresponds to
the effect you wish to edit.
The parameters for the selected Effector appear in the
display.
(@) EFFECT PARAMETER
—< £
& Ny On, Re, 25
Ug (oh) ha le S
Lia Ug "Re
REN,
NV
The Effector name
being changed is displayed
The Parameter for the setting
being changed flashes
Value
2 Use the PARAMETER [-#] [ B] to make the unit with the
Effector to be changed start to flash.
* Holding down a PARAMETER [<4] [®] causes the displayed
parameters to change sequentially.
3 Use the VALUE knob to change the setting. By pressing the
VALUE knob while you rotate it, you can make the value
change faster.
4 Repeat steps 2 and 3 to finish making effect settings.
5 Ifnecessary, switch the Effector in step 1 and continue with
the procedure.
6 When you finish making settings...
- Ifyou wantto continue with changing another item, make
the modification according to what you want to do.
— Ifyouwish to save the settings, use the Write operation
(p.22).
16