Klarstein GLACIAL PRO Manual page 23

• When the unit is restarted after a period of inactivity, it may not be able to
pump up enough water. In this case, the ADD WATER indicator lights up.
Simply press the ICE MAKING (on/off) button again to restart the device.
• To keep the ice clean, change the water in the water tank at least once a day.
If you will not be using the device for a long time, drain the water and clean
the device.
• If the compressor does not work due to lack of water, full ice or power failure,
it will start with a delay of 3 minutes after being switched on again.
• Always fill with fresh water before starting ice production.
Problem Potential cause
The device is The power voltage is too low.
exceptionally loud
and buzzes.
The water There is not enough water in the
indicator comes tank.
on.
The indicators on The fuse is broken or the device is
the control panel switched off.
do not light up.
The unit runs but Problem with the coolant.
is not making ice.
The compressor is broken.
The fan motor is damaged.
All lights flash at The connection of the motor is
the same time. loose.
The motor is jammed, the motor
fails or is damaged.
The micro switch is damaged.
The ice comes The moving detection mechanism
up to the ice bar on the ice bar is broken.
but the ice holder
The display is broken.
indicator does not
come on.
Possible solution
Stop the device and plug the device
into an outlet that matches the
specified voltage.
Top up with water.
Replace the fuse or switch on the
device.
Contact a specialist company to
have it checked and repaired.
Contact a specialist company to
have it checked and repaired.
Contact a specialist company to
have it checked and repaired.
EN
23