Volume Adjustment - Raddy RF206 User Manual

4: Power Switch:
Toggle Switch:
Insert the AC power cord into the [AC-IN] power port (located on the left side of the
device) or insert four AA dry batteries [1.5V×4AA]. The LCD will display the time.
Move the switch to the [ON] position to power on the radio.
Move the switch to the [OFF] position to power off the radio.。
5:

Volume Adjustment:

In operating mode, you can adjust the volume as needed by rotating the volume
knob. Turning the volume
the volume, while turning it in the 'MAX' direction increase the volume."
6: Listening to Radio Broadcasts:
6.1: In the radio powered-on state, push the four-position switch
mode button.
This product can receive FM, medium wave, and short wave. The reception ranges
and step values for each band are as follows:
Frequency Band Reception Range
AM 1: 522-1710KHZ
AM 2: 520-1710KHZ
FM FM: 64.00-108.00MHZ
SW short wave: 2.300-23.000MHZ
6.2: Method for Adjusting the Medium Wave Step Value:
For medium wave reception, different countries have different requirements, and you
can adjust it according to your needs.
Clock Display Mode: Long press the [
and the LCD screen will display the "10KHZ" character.
Press the [
10KHZ." After about 1.5 seconds, the number disappears, and the last selected step
value becomes the default.
Note: In the United States, Canada, Mexico, and other North and South American
countries, the medium wave step value must be set to 10KHZ, while in other
countries, the step value is 9KHZ.
6.3: This product supports multiple tuning methods: Manual tuning, automatic
radio station search, and full automatic radio station storage.
6.3.1: Manual Tuning: Rotate the [
frequency in each band by the minimum step value.
6.3.2: Automatic Radio Station Search: Press and hold [▲or▼] for 2 seconds to
quickly search for radio stations in an upward or downward direction using the
minimum step value. When a station with a signal is found, the search stops, and the
station starts playing.
6.3.3: Full Automatic Radio Station Storage: In the radio broadcast mode, press and
hold [ ] for 2 seconds to initiate a full automatic scan for radio stations. The
device will automatically store stations from the lowest to the highest frequency
point. During the full automatic scanning process, the LCD will display "SCAN" in
] button again, and it will toggle between the step values "9KHZ /
knob in the 'MIN' direction decrease
9KHz (Factory default is a 9KHz step value for AM)
10KHZ
0.1MHZ
0.005HZ
] button for approximately 3 seconds,
] knob to increase or decrease the
2
Step Value
to select the