Raddy RF206 User Manual page 9

4: Netzschalter:
Toggle Switch:
Stecken Sie das Netzkabel in den Netzanschluss [AC-IN] (auf der linken Seite des
Geräts) oder legen Sie vier AA-Trockenbatterien [1,5 V × 4 AA] ein. Das LCD
zeigt die Uhrzeit an.
Bewegen Sie den Schalter in die Position [ON], um das Radio einzuschalten.
Bewegen Sie den Schalter in die Position [OFF], um das Radio auszuschalten.
5: Lautstärkeeinstellung:
In operating mode, you can adjust the volume as needed by rotating the volume
knob. Turning the volume
while turning it in the 'MAX' direction increase the volume."
6: Hören von Radiosendungen:
6.1: Drücken Sie im eingeschalteten Zustand des Radios den
Vier-Positions-Schalter, um die Modustaste auszuwählen.
Dieses Produkt kann FM, Mittelwelle und Kurzwelle empfangen. Die
Empfangsbereiche und Schrittwerte für jedes Band sind wie folgt:
6.2: Methode zum Anpassen des Mittelwellen-Schrittwerts:
Frequency Band Reception Range
AM 1: 522-1710KHZ
AM 2: 520-1710KHZ
FM FM: 64.00-108.00MHZ
SW short wave: 2.300-23.000MHZ
For medium wave reception, different countries have different requirements, and you
can adjust it according to your needs.
Clock Display Mode: Long press the [
the LCD screen will display the "10KHZ" character.
Press the [ ] button again, and it will toggle between the step values "9KHZ /
10KHZ." After about 1.5 seconds, the number disappears, and the last selected step
value becomes the default.
Note: In the United States, Canada, Mexico, and other North and South American
countries, the medium wave step value must be set to 10KHZ, while in other
countries, the step value is 9KHZ.
6.3: Dieses Produkt unterstützt mehrere Abstimmungsmethoden: manuelle
Abstimmung, automatische Suche nach Radiosendern und vollautomatische
Speicherung von Radiosendern.
6.3.1: Manual Tuning: Rotate the [
frequency in each band by the minimum step value.
6.3.2: Automatic Radio Station Search: Press and hold [▲or▼] for 2 seconds to
quickly search for radio stations in an upward or downward direction using the
minimum step value. When a station with a signal is found, the search stops, and the
station starts playing.
6.3.3: Full Automatic Radio Station Storage: In the radio broadcast mode, press and
hold [ ] for 2 seconds to initiate a full automatic scan for radio stations. The
device will automatically store stations from the lowest to the highest frequency
point. During the full automatic scanning process, the LCD will display "SCAN" in
the upper left corner and the station's address number in the upper right corner as
"M**" (the number represents the station's address number). After completing one
knob in the 'MIN' direction decrease the volu
Step Value
9KHz (Factory default is a 9KHz step value for
AM)
10KHZ
0.1MHZ
0.005HZ
] button for approximately 3 seconds, and
] knob to increase or decrease the
8
me,