Connection To Pc, Front Control - Philips IJ6B2W/76 Service Manual

S et Tin g U p t h e Monitor
To set up the monitor, ensure that the power is turned off to the
monitor, computer system, and other attached devices, then
follow these steps:
1. Place the monitor in a convenient, well-ventilated location
near your computer.
2. Connect one end of the monitor signal cable to the video
connector on the rear panel of the computer, and the other end
to the back of the monitor.
3. Connect the power cable to the back of the monitor, and the
other end of the power cable to an electrical wall outlet.
4. Adjust the monitor as needed for your comfort using the
monitor s tilt, swivel, and height adjustment capabilities.
Connection to PC
Re movi n g t h e M on i tor B as e
You can remove the monitor base to mount the monitor on a wall,
swing arm, or other mounting fixture. Read the caution and
warning statements below before beginning the procedure.
Moun tin g t h e Monitor
1. Remove the monitor base. Refer to R e moving the Monitor
Base steps in the previous section.
When the base is removed, four threaded mounting holes are
exposed on the monitor panel to be used for mounting
purposes. These mounting holes are spaced 100 mm apart
and are compliant with the Video Electronics Standards
Association (VESA) standard for mounting flat panel
displays.
2. Mount the monitor to a swing arm or other mounting fixture
by following the instructions included with the mounting
fixture to be used.
5
HP L2335
Go to cover page