Panasonic VL-W1-N Series Setup And Maintenance Manual page 34

3. Laser pumping switch (with white LED): LASER SUPPLY
This is the switch for starting laser pumping.
LED flashes (approx. 15sec) in white when the switch is pressed, and it lights up when the laser irradiation becomes
enabled.
4. Remote switch (with white LED): REMOTE
This is the switch for activating communication control and I/O control. This indicator is lighted-up by pressing this
switch, and is changed into remote mode.
5. Alarm reset switch (with blue LED): ALARM RESET
This switch is used to reset the system when an alarm generates. LED lights up in blue when an alarm generates.
Release the cause of alarm and press this switch.
6. Console connector: CONSOLE
This is the connector for console (option).
7. USB connector A: USB MEDIA
This is the terminal for connecting the USB media or USB mouse.
For registering or saving data in the laser welding machine, connect a commercially available USB. (USB media with
security features cannot be used.)
You can also connect a USB mouse when setting by using a commercially available monitor.
A USB port is also mounted at the back.
• Do not connect the USB devices other than a USB media or a USB mouse.
8. USB connector B: PC
This is the connector for PC.
When importing the drawing file (.VEC) created by the attached software "Logo Data Editing" to the laser welding
machine, connect the PC with the attached USB cable.
9. Controller air-cooling inlet
The air inlet for cooling the controller. The air filter is attached.
34
ME-VLW1N-SM-1