Dometic EA 24B Installation And Operating Manual page 15

Fig.  on page 3
Inserting the shelf supports
Proceed as shown.
Fig.  on page 3
Inserting the shelves
Proceed as shown:
EA 24B: Fig. 
Selecting the installing location
WARNING! Risk of injury
Move the device with at least 2 people.
• The intended ambient temperature and the cli-
mate class can be found in the technical data (see
Technical data) and on the data plate of the de-
vice.
• The ground must be level and sufficiently stable to
support the device when fully loaded.
• The device must be positioned so that the plug is
accessible.
• Note the information on the electrical connection
(chapter Connecting the device to the power sup
ply).
• Do not install the device in an area with excessive
moisture.
• Remove all the inner and outer packaging material
before setting up the device.
Placing the device
NOTE
• Observe the device's dimensions
(Technical
(Fig. ) when installing the device.
• Ensure that the door can be opened
completely and is not blocked by other
objects.
Fig.  on page 4
on page 4
data) and safety distances
EA 24B
1. Ensure that the door is locked when moving the de-
vice.
2. If necessary, tape the door with duct tape.
3. Position the device.
EA 24D only
1. Fix the drawers with duct tape when moving the
device.
2. Attach the anti-tip brackets on the floor.
Fig.  on page 5
3. Position the device.
Connecting the device to the power
supply
NOTICE! Damage hazard
• Do not modify or damage the plug.
• Do not plug the device in an socket
that can be turned off by a switch or
pull chain.
• To avoid voltage drops and loss of per-
formance do not use adapt-ers, exten-
sion cords, or power strips.
• Ensure that an residual current circuit
breaker is installed to the power sup-
ply. Seek advice from a trained electri-
cian.
• Observe the input voltage (see
cal data).
NOTE Let the device stand upright for 24 h
before connecting it to the power supply.
Plug the device into a AC socket.
Adjusting the feet
NOTE The bottom of the device must be
horizontal.
Ensure the device is level by adjusting the feet.
Fig.  on page 5
EA 24B, EA 24D EN
Techni
13