Advertisement
INSTALLATION
How to Install the Faucet
Shut off water supply. Cut away the extending part of the base
protector(1) in accordance with the tile surface. Remove plug(2) from
base. Remove protector(3) from the faucet.
4
8
Slide up escutcheon kit(4). Install the faucet. NOTE: Keep the faucet
vertical to base, to avoid damaging the o-ring on the bottom.
5
6
Keep the spout pointing to tub. Fix the faucet to the base with screws(5)
7
3
and washers(6) through flange(7). Tighten the screws with hex
wrench(8).
1
2
Slide down the escutcheon kit, make sure it against the finished floor.
How to Install the Handshower
Remove the protector from diverter kit(9).
If needed, install the regulator(10) into the handshower(11) according to
11
installation instruction.
the diverter kit and handshower with the hose. Tighten all connections.
10
9
12
Hang the handshower on the bracket(14) of the faucet.
14
12
13
How to Operate the Handshower
Press the buttons of the handshower to change the water flow.
Katalyst Air
Intense Massage
1345464-2A-C
Put the
washers(12) into the hose(13). Connect
2
How to Maintain the Handshower
Any debris or mineral build-up may cause the flow stream to become
distorted or reduce the flow rate. To remove the debris or mineral
build-up, run water through the handshower, firmly press or rub your
finger back and forth across the rubber nozzles.
Remove and clean the screen washer.
INSTALLATION CHECKOUT
Ensure that all coupling nuts are tight. Ensure that the handle is in the off
position.
11
Turn on the main water supply, and check for leaks. Repair as needed.
Remove the handshower
on the faucet handle. Run hot and cold water through the spout for about
one minute to remove any debris. Shut off the faucet. Reinstall the
handshower and aerator.
15
CLEANING INSTRUCTIONS
All Finishes: Clean the finish with mild soap and warm water. Wipe entire surface completely dry with clean soft
cloth. Many cleaners may contain chemicals, such as ammonia, chlorine, toilet cleaner etc. which could adversely
affect the finish and are not recommended for cleaning.
Do not use abrasive cleaners or solvents on Kohler faucets and fittings.
1345464-2A-C
(11). Remove the aerator(15) with a coin. Turn
3
Advertisement
