DTP32
DTP32 Series II
C
ALIBRATION
8 Click Measure.
Follow the on-screen instructions to feed the measurement page through the DTP32.
N
:
The DTP32 Series II does not have an edge guide for the page. Position the page so
OTE
that the strip to be measured is lined up directly under the alignment mark.
The Status field displays instructions for selecting the port and feeding the measurement page
through the DTP32 four times, once for each color strip.
9 When the Status field indicates that the measurements were read successfully, click Accept.
10 Click OK in the Measure dialog box.
11 Click Apply in the Calibrator dialog box to implement the new calibration set.
12 Click OK in the Information dialog box.
This completes the calibration process.
38