Advertisement
Quick Links
Installation Guide
Fan Replacement
iC2-Micro Frequency Converters
1 Overview
1.1 Description
This installation guide explains how to replace the cooling fan for iC2-Micro Frequency Converters.
1.2 Items Supplied
Use these instructions with the following items.
Table 1: Items Supplied
Code number
132G0215
132G0216
132G0217
132G0218
132G0219
132G0220
1.3 Safety Information
Only qualified personnel are allowed to replace the cooling fan described in this installation guide.
For important information about safety precautions for installation, refer to the drive's operating guide.
DISCHARGE TIME
The drive contains DC-link capacitors, which can remain charged even when the drive is not powered. High voltage can be
present even when the warning indicator lights are off.
-
Stop the motor, disconnect AC mains and permanent magnet type motors, and remove DC-link supplies, including battery
back-ups, UPS, and DC-link connections to other drives.
-
Wait for the capacitors to discharge fully and measure it before performing any service or repair work.
-
The minimum waiting time is 4 minutes for MA02c and MA01a–MA03a drives, and 15 minutes for MA04a–MA05a drives.
Danfoss A/S © 2024.01
Item description
Cooling fan, MA02c
Cooling fan, MA01a
Cooling fan, MA02a
Cooling fan, MA03a
Cooling fan, MA04a
Cooling fan, MA05a
W A R N I N G
AN406328028809en-000301 / 130R1241 | 1
Advertisement
Related Manuals for Danfoss 132G0215
Summary of Contents for Danfoss 132G0215
- Page 1 Wait for the capacitors to discharge fully and measure it before performing any service or repair work. The minimum waiting time is 4 minutes for MA02c and MA01a–MA03a drives, and 15 minutes for MA04a–MA05a drives. Danfoss A/S © 2024.01 AN406328028809en-000301 / 130R1241 | 1...
- Page 2 Danfoss can accept no responsibility for possible errors in catalogs, brochures, and other printed material. Danfoss reserves the right to alter its products without notice. This also applies to products already on order provided that such alterations can be made without subsequential changes being necessary in specifications already agreed.