Adjustable Clutch - Bosch GSR18V-800FC Operating/Safety Instructions Manual

Gear Shifting
(Fig. 18)
Your tool is equipped with two separate
gear ranges, low gear 1 and high gear 2. Low
gear provides high-torque and slower drill-
ing speeds for heavy duty work or for driving
screws. High gear provides faster speeds for
drilling lighter work. To change speeds slide
switch 4, to the high 2 or low position 1.
ATTENTION: If your tool appears to be run-
ning, but the chuck will not turn, check to
make sure the gear shifter is pushed fully into
desired setting.

Adjustable Clutch

(Fig. 19)
Your tool features 25 clutch settings. Output
torque will increase as the Adjustable Clutch
3 is rotated from 1 to 25. The tool will stop
rotating as soon as the set torque is reached
during operation.
Brake
When the trigger switch is released it acti-
vates the brake to stop the chuck quickly.
This is especially useful in the repetitive driv-
ing and removal of screws.
Temperature Overload Protection
Avoid using battery operated tools continu-
ously, for long periods of time, while subject-
ing the tool to overload conditions, such as
drilling with large diameter accessories into
hard materials. Using battery powered tools
at extreme loads, may cause the battery to
exceed its allowable operating temperature
range. When the battery exceeds normal op-
erating temperature caused by overload, the
speed of the tool may be reduced and the
tool may appear to lose power. To regain the
tool's full performance, the battery must be
allowed to cool, until the operating tempera-
ture returns to normal.
2610070415 GSR18V800FC 202310.indd 21
Operating Instructions
Fig. 18
Fig. 19
Low Position 1
(3)
High Position 2
(4)
21
10/24/23 3:15 PM