Installation - Electrolux ERT25G2HUG Instruction Manual

Table of Contents

Advertisement

Available languages

Available languages

11 electrolux installation

Installation

Choosing the location
In order to ensure that heat dissipates
rapidly and that the refrigerator operates
efficiently, with low energy consumption,
we recommend leaving the following
minimum distances between the
refrigerator and the walls and ceiling:
Top: 30cm
Sides: 10cm
Door side: 10cm
Back: 10cm
Install the refrigerator in a well-ventilated
area, away from direct sunlight and from
heat sources, such as ovens and
burners, from inflammable materials,
and from areas where water is frequently
used, such as sinks.
Do not install the refrigerator outdoors.
Leveling the refrigerator
The refrigerator cannot be set
horizontally or tilt more than 45° or
upside-down.
Use a level with glass-enclosed bubble
to verify whether the refrigerator is
properly leveled, with the four feet firmly
on the floor.
If the refrigerator needs to be adjusted,
carefully lean it and turn the front
adjustable leveling feet until it is firmly
installed.
Proper leveling prevents movement,
30cm
(top)
10cm
(back)
10cm
(side)
10cm
(door side)
Proper leveling prevents movement,
vibration and other problems.
Do not substitute the original refrigerator
legs.
Wait at least 2 hours before plugging the
refrigerator in this will prevent operating
problems.
Electrical installation
Before turning on the refrigerator, check
to see if the voltage of the outlet to be
used is the same as that indicated on the
tag located close to the plug (along the
power cord) or on the refrigerator's
identification label.
Check to see that the refrigerator's plug
is not connected on top of the power
cord.
Connect the refrigerator to its own outlet.
Do not use an extension cord or adaptor
plug.
For your safety, ask an electrician to
verify the condition of the electric wiring
in the area where the refrigerator will be
installed.
The wires leading to the outlet into which
the refrigerator will be plugged should be
made of copper and be at least 2,5 mm
wide. For greater safety, consult the
legislation on electrical installations in
your country.
installation electrolux 12
2

Advertisement

Chapters

Table of Contents
loading

Table of Contents