LuxenHome WHF728 Instruction Manual

Product Name: Modern Gray Resin 3-Urn Pots Outdoor Fountain with LED Lights
SKU #: WHF728
Thank you for purchasing this LuxenHöme product. This product has been manufactured with the
highest standards of safety and quality.
PLEASE READ ALL INSTRUCTIONS BEFORE ASSEMBLY.
Unpack all parts from Styrofoam and bubble wrap inside the carton to ensure there are no missing or
damaged parts. If any parts are missing or damaged, do not attempt to assemble or use the product.

CARTON CONTENTS:

Description
Fountain
Pump
Compatible Pumps for this fountain:
Pump Model No.
JR600/LED
JB650/LED
YH560/LED
YH-LV130T
Tools required for assembly: No tools required for assembly.

Assembly Instructions:

1. Unpack the contents of the box and check to make sure that all items are accounted for and in good
condition.
2. Select a flat, level surface for the assembly and final location of your fountain.
3. Insert the water tube located at the small opening at the back of the fountain to the pump. Insert the LED
connector into the pump connector, and twist to tighten. Place the pump inside the fountain opening in
back.
4. Add clean water into the any of the pots in the front of the fountain. The water level should be
approximately 30mm lower than the edge of the basin.
5. Connect the power cable to outlet. If installed properly, water flow in the fountain will begin shortly.
6. Please do not use the electrical plug in wet weather conditions. Please note: On first use, there may be air in
the pump. It may take several minutes until all the air escapes.
7. To eliminate the possibility of water damage around your fountain, check for leaks and excessive splashing
after the initial setup of your fountain. It is highly recommended that this fountain be placed in an area
where it cannot be damaged.
8. Do not leave your fountain running for extended periods of time when no one is present to observe the
performance.
9. Check the area around your fountain on a regular basis to ensure that there is no leakage.
10. Please refresh the fountain with water each week to ensure it in good condition.
11. Do not add any harmful chemicals to the water as it may alter the finish.
Quantity
1
1
Instruction Manual
SAVE THESE INSTRUCTIONS–This manual contains
important safety and operating instructions for power units.