Advertisement
Product Name:
SKU #:
Thank you for purchasing this LuxenHöme product. This product has been manufactured with the
highest standards of safety and quality.
PLEASE READ ALL INSTRUCTIONS BEFORE ASSEMBLY.
Unpack all parts from Styrofoam and bubble wrap inside the carton to ensure there are no missing or
damaged parts. If any parts are missing or damaged, do not attempt to assemble or use the product.
CARTON CONTENTS:
Description
Fountain
Pump
Compatible Pumps for this fountain:
Pump Model No.
JR450/LED
JB450/LED
YH707/LED
YH-LV110T
Tools required for assembly: No tools required for assembly.
Assembly Instructions:
1. Unpack the contents of the box and check to make sure that all items are accounted for and in good
condition.
2. Select a flat, level surface for the assembly and final location of your fountain.
3. At the back of the fountain, insert the water tube into the pump. Insert the LED connector into the pump
connector, and twist to tighten. Place the pump upright inside the fountain.
4. Add clean water to the fountain. The water level should be approximately 30mm lower than the edge of the
basin.
5. Connect the power cable to outlet. If installed properly, water flow in the fountain will begin shortly.
6. Please do not use the electrical plug-in wet weather conditions. Please note: On first use, there may be air in
the pump. It may take several minutes until all the air escapes.
7. To eliminate the possibility of water damage around your fountain, check for leaks and excessive splashing
after the initial setup of your fountain. It is highly recommended that this fountain be placed in an area
where it cannot be damaged.
8. Do not leave your fountain running for extended periods of time when no one is present to observe the
performance.
9. Check the area around your fountain on a regular basis to ensure that there is no leakage.
10. Please refresh the fountain with water each week to ensure it in good condition.
11. Do not add any harmful chemicals to the water as it may alter the finish.
Modern Gray Resin 4-Bowls Round Outdoor Fountain with LED Lights
WHF734
Quantity
1
1
Instruction Manual
SAVE THESE INSTRUCTIONS–This manual contains
important safety and operating instructions for power units.
Advertisement
Table of Contents
Related Manuals for LuxenHome WHF734
Summary of Contents for LuxenHome WHF734
- Page 1 Product Name: Modern Gray Resin 4-Bowls Round Outdoor Fountain with LED Lights SKU #: WHF734 Thank you for purchasing this LuxenHöme product. This product has been manufactured with the highest standards of safety and quality. PLEASE READ ALL INSTRUCTIONS BEFORE ASSEMBLY.
- Page 2 Instruction Manual SAVE THESE INSTRUCTIONS–This manual contains important safety and operating instructions for power units. Product Name: Modern Gray Resin 4-Bowls Round Outdoor Fountain with LED Lights SKU #: WHF734 Note: The above diagram is for illustrative purposes only.
- Page 3 Product Name: Modern Gray Resin 4-Bowls Round Outdoor Fountain with LED Lights SKU #: WHF734 MAINTENANCE OF YOUR PUMP: Keep the water clean – clean water will prolong the life of your pump. •...
- Page 4 Product Name: Modern Gray Resin 4-Bowls Round Outdoor Fountain with LED Lights SKU #: WHF734 Check the water level regularly to ensure the pump is completely submerged during operation. The pump • should be fully submerged during operation. Do not add water while operating the product. Always disconnect the pump from the power source before adding water.
Need help?
Do you have a question about the WHF734 and is the answer not in the manual?
Questions and answers