Teka LP8 820 VR01 Instruction Manual page 22

Insert the drain hose into a drain pipe with a minimum diameter of 40mm, or let it run into the sink, making sure to
avoid bending or crimping it. The top of the hose must be less than 1000mm.
NOTE
The top of the hose
must be less than
1000mm.
Improper connection of the equipment earthing conductor can result in the risk of an
for personal safety:
electric shock.
DO NOT USE AN EXTENSION CORD OR AN ADAPTER PLUG WITH THIS APPLIANCE.
Check with a qualified electrician or service representative if you are in doubt whether the
DO NOT, UNDER ANY CIRCUMSTANCES, CUT OR REMOVE THE
appliance is properly earthed.
CONNECTION FROM THE POWER CORD.
Do not modify the plug provided with the appliance. If the plug does not fit properly to the
outlet, please have a qualified electrician to install a proper outlet.
Connect the cold water supply hose to a threaded 3/4(inch) connector and make sure
that it is fastened tightly in place.
If the water pipes are new or have not been used for an extended period of time, let the
water run to make sure that the water is clear. This precaution is needed to avoid the
risk of the water inlet to be blocked and damage the appliance.
Please close the hydrant after using.
Front
Drain pipe
A
B
φ 40mm
16
EARTHING
Counter