Memory; Removing The Memory - Dell OptiPlex 3000TC Service Manual

Steps
1. Align the notch on the M.2 2230 solid-state drive with the tab on the M.2 card slot on the system board.
2. Slide the M.2 2230 solid-state drive at an angle into the M.2 card slot on the system board.
3. Replace the screw (M2x3.5) to secure the M.2 2230 solid-state drive to the M.2 card slot on the system board.
4. Align the screws of the solid-state drive heat sink with the holders on the system.
5. Place the solid-state drive heat sink on the M.2 2230 solid-state drive.
6. Tighten the two captive screws to secure the solid-state drive heat sink on the system.
Next steps
1. Install the side cover.
2. Follow the procedure in

Memory

Removing the memory

Prerequisites
1. Follow the procedure in
2. Remove the side cover.
About this task
The following image indicates the location of the memory and provides a visual representation of the removal procedure.
after working inside your
before working inside your
computer.
computer.
Removing and installing components 17