Table of Contents
Advertisement
USER GUIDE
REPLACING ICE MAKER ASSEMBLY
1. Disconnect unit from power and remove back panel.
2. Disconnect all wires at bell connectors (5 wires-Models
BI95, BI98 or SP18; or Plug-Models).
3. Remove capillary tube from sensing tube on ice maker
assembly (2).
4. Remove water inlet tube.
5. Remove front cover (3)
6. Advance ejector blades to the 3:00 position by turning
the 5/16" hex head on the small brass gear
counterclockwise (4).
7. Remove two screws from the side wall of evaporator
(5).
8. Remove screws from the bottom of the evaporator
plate.
9. Remove ice maker assembly from evaporator shelf.
10.Clean alumilastic from evaporator shelf.
11.Apply 1/4" layer of fresh alumilastic to heater side of
new ice maker.
12.Replace parts in reverse order of removal.
13.Reconnect all wires.
14.Insert capillary tube into ice maker sensing tube.
15.Insert water inlet tube.
16.Apply permagum to all exit holes. Mount back panel.
Troubleshooting - Extended 1
17.Replace the back panel.
18.Plug in unit and test.
220 Volt Conversion List
All models listed in this manual are equipped to run on
110/115 volt. This document is a conversion list for the
applicable 220 volt parts for the following models:
• SP18
• BI95
• BI98
• SS1095
110V P/N
220V P/N
5263-S
5195
80-39015-00
628109
402
619
402-29/1175
620
2552A
2555A
5402-S
5404-S
150
650
5414
5418
5413
5417
50
Description
Fan Motor
I.M. motor (ice makers)
Ice maker assembly -
Models SP18, BI95, BI98
and model SS1095
Ice maker assembly -
Models SP18, BI95, BI98
and model SS1095
Water valve
Compressor (ice makers)
Faceplate assembly
Relay
Overload
Advertisement
Table of Contents
