Section 6 − Installation; Serial Number And Rating Label Location; Installing Welding Gun - Hobart Welding Products Trek 180 Owner's Manual

6-1. Serial Number And Rating Label Location

The serial number and rating information for this product is located on the back. Use rating label to determine input power requirements and/or rated
output. For future reference, write serial number in space provided on back cover of this manual.

6-2. Installing Welding Gun

1
.
Be sure that gun end is tight
against drive assembly.
Incorrect Installation −
Gun Not Seated
SECTION 6 − INSTALLATION
2
3
Exposed O-rings will
cause shielding gas
leakage.
4
3
Correct Installation −
Gun Fully Seated
1 Drive Assembly
2 Gun Securing Knob
3 Gun End
Loosen knob. Insert end of gun
through opening in front panel
until it bottoms against drive
assembly. Tighten knob.
Welding gun must be fully inserted
to prevent leakage of shielding gas.
4 Gun Trigger Plug
Insert plug into receptacle. Tighten
threaded collar.
Close door.
244 704 / Ref. 244 703
OM-232 661 Page 15