Threading Welding Wire - Hobart Welding Products Trek 180 Owner's Manual

6-11. Threading Welding Wire

Tools Needed:
1
Open pressure assembly. Make sure
feed roll is set to correct groove to
match wire size (see Section 8-4).
OM-232 661 Page 22
1 2 3 5
3
Straighten approximately 3 or 4 in. (76 or 102 mm) of wire before inserting wire
into guides. Push wire thru guides into gun; continue to hold wire.
1 Wire Spool
4
2 Welding Wire
3 Inlet Wire Guide
4 Pressure Adjustment Knob
5 Drive Roll
6 Gun Conduit Cable
6
Lay gun cable out straight.
2
.
Hold wire tightly to keep it from unraveling.
6 in
(150 mm)
Pull and hold wire; cut off end.
4 in
(102 mm)