Advertisement
OUTPUT CONNECTIONS - 2-CHANNEL MODE (STEREO)
Connect the left speaker to the binding posts marked OUTPUT 1 and the right speakers to the
binding posts marked OUTPUT 2.
Observe the phasing of the speakers. Most connectors on speaker cabinets are either color
coded or marked +,
Connect the black or minus (—) terminal on the speaker cabinet to the black binding post on the
amplifier. Connect the other speaker terminal to the fuseholder, if required, and the fuseholder
to the red binding post. Check to see that the MONO-STEREO switch on the rear of the amplifier
is in the STEREO position.
Ideally, the output leads should be connected to the amplifier with standard banana plugs;
however, the five way action of the binding posts permit the use of tinned wires or spade lugs.
Remember, of cource, to put a fuse in series with the load.
CAUTION-HAZARDOUS ENERGY
Any high power amplifier is capable of destroying almost any loudspeaker, so that using these
amplifiers, do not exceed the speaker's capability or suitable fusing must be required.
OUTPUT CONNECTIONS-BRIDGE MODE (MONO)
Follow the same procedure as outlined for 2-channel mode, but connect the single output across
the two red binding posts of the OUTPUT 1 and OUTPUT 2. Do not connect anything to the
OUTPUT 1 or OUTPUT 2 ground binding posts.
Designate the OUTPUT 1 red binding post plus (-i-) and the OUTPUT 2 red binding post minus
(-). A fuse is required in only one load.
Check to see that the MONO-STEREO switch on the rear of the amplifier is in the MONO
position.
10
Advertisement
