Section 2: Setup; Unpacking; Needed For Setup; Inventory - Grizzly T33296 Owner's Manual

This
serious
to untrained users. Read
through this entire manu-
al to become familiar with
the controls and opera-
tions before starting the
machine!
Wear safety glasses during
the entire setup process!

Unpacking

This machine was carefully packaged for safe
transport. When unpacking, separate all enclosed
items from packaging materials and inspect them
for shipping damage. If items are damaged,
please call us immediately at (570) 546-9663.
IMPORTANT: Save all packaging materials until
you are completely satisfied with the machine and
have resolved any issues between Grizzly or the
shipping agent. You MUST have the original pack-
aging to file a freight claim. It is also extremely
helpful if you need to return your machine later.

Needed for Setup

The following items are needed, but not included,
for setup and assembly of this machine.
Description
• Hex Wrench 6mm....................................... 1
• Phillips Head Screwdriver #2 ..................... 1
• Combination Wrench 10mm....................... 1
• Combination Wrench 19mm ....................... 1
• Adjustable Wrench 0–20mm...................... 1
-6-

SECTION 2: SETUP

machine presents
injury hazards
Qty

Inventory

The following is a list of items shipped with your
machine. Before beginning setup, lay these items
out and inventory them.
If any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
Inventory (Figures 1–2)
Miter Stand Assembly
A.
Clamping Rails ........................................... 2
B.
— Carriage Bolts M8-1.25 x 55
Flat Washers 8mm ................................ 4
—
Lock Nuts M8-1.25................................. 4
—
Offset Mounts............................................. 2
C.
— Carriage Bolts M8-1.25 x 16
Flat Washers 8mm
—
Hex Nuts M8-1.25
—
D. Handle Bars................................................ 2
— Phlp Hd Screws M6-1 x
— Hex Nuts M6-1 ...................................... 4
Skid Rail ..................................................... 1
E.
— Phlp Hd Screws M6-1 x
— Hex Nuts M6-1 ...................................... 4
T-Supports.................................................. 2
F.
— Knobs .................................................... 2
— Carriage Bolts M6-1 x 55....................... 2
G. Angle Flanges ............................................ 2
Knob Bolts ............................................. 2
—
H. Wheels ....................................................... 2
— Axle Bolts M12-1.75 x
— Lock Nuts M12-1.75
Figure 1. Miter stand assembly inventory.
Model T33296 (Mfd. Since 07/23)
Qty
............................... 1
.................. 4
.................. 2
................................ 2
.................................. 2
45.................... 4
45.................... 4
120...................... 2
............................... 2
A