Installing And Removing The Clean Water Tank; Installing And Removing The Dirty Water Tank; Installing And Removing The Brush Roller - Philips Cordless Wet & Dry Vacuum 4000 Series User Manual

Installing and removing the clean water tank

• Installation (as shown in Figure 1): Align the limit slots at both ends of the clean water tank with
the limit slots on the main unit and push it down gently. When you hear a click, it indicates that the
installation is successful.
• Removal (as shown in Figure 2): Hold the main unit tightly and lift up the fresh water tank to remove it.
1

Installing and removing the dirty water tank

• Installation (as shown in Figure 1): Place the bottom of the dirty water tank on the opening of the main
unit and then push it inward slightly. When you hear a click, it indicates that the installation is successful.
• Removal (as shown in Figure 2): Hold the main unit tightly and press down the lock, then gently pull out
the dirty water tank to remove it.
1

Installing and removing the brush roller

• Installation (as shown in Figures 1 and 2): Align the bayonet on the brush roller lock with the slot and
push the brush roller to the bottom so that it is in full contact with the brush roller shaft. Turn it clockwise
to the end and lock it. When you hear a click, it indicates that the installation is successful.
English
10
2
1
2
2