Run A Test Cycle - Midea MLV43A3AWW User's Manual & Installation Instructions

Run a test cycle

Run a test cycle to make sure that your washer is properly installed.
1. Load about 6 pounds (2.7 kg) of laundry into the tub.
2. Select the Cycles knob to turn on your washer.
3. Turn the cycle selector to select the Rinse & Spin cycle.
4. Press the Start Pause button to start the test cycle. Your washer
should not rock or vibrate excessively when water fills the tub or
when washing or spinning. The washer should drain well during the
spin cycle.
Caution
•
If you detect any water leaks while the washer is filling or draining,
check the water connections. See Connect the water hoses on
page 19 or Connect the drain hose on page 21.
•
If the washer rocks and/or vibrates excessively, level it again. See
Level your washer on page 24.
26