Replace the can
Each can will provide up to 120 sprays.
When it's time to replace the can, press
and hold the power button; the LED will
glow red. Continue to hold the button
until the LED shuts off, then release.
Unlock the lid and remove the empty can.
Remove the cap from a new PetSafe
SSSCAT
Refill Can and place it in the
™
base, turning it so the spray nozzle points
to the triangle on the top edge of the
base. Replace the lid and turn it clockwise
to lock.
Switch modes
The spray deterrent is set to long-
range mode by default. If it seems to
be activating from too far away, try
switching to short-range mode:
1. With the spray deterrent on, press
and hold the power button for 5
seconds. You'll see the LED flash red
once and then, a few seconds later,
begin quickly flashing red.
2. When you see the quick red flashes,
release the power button. The spray
deterrent will enter short-range mode
and turn off automatically; turn it
on again to operate in short-range
mode.
To switch back to long-range mode:
1. With the spray deterrent on, press
and hold the power button for 5
seconds. You'll see the LED flash red
once and then, a few seconds later,
begin quickly flashing green.
®
2. When you see the quick green
flashes, release the power button.
The spray deterrent will enter
long-range mode and turn off
automatically; turn it on again to
operate in long-range mode.
9
Need help?
Do you have a question about the SSSCAT and is the answer not in the manual?